Security Link SL150 Guia de Resolução de Problemas descarregar pdf (Página 117)

Section 23 - System Operation

23–3

Wired keypads contain the following dedicated quick arming keys :

No security code is required to arm the system using the A, B, or C keys. However, a security

code is always required to disarm the system.

A = arm AWAY

B = arm STAY

C = arm INSTANT (if not programmed for Macros)

D = When pressed, if programmed to do so, will send a special message to a pager and

display “Page in progress” on the keypad for 30 seconds.

The message it sends is coded as 999-9999 and signifies ANY pre-arranged message

the user and recipient have agreed on, such as “call office,” “call home,” etc.

SUMMARY OF ARMING MODES

Features for Each Arming Mode

Arming

Mode

Exit Delay Entry Delay

Perimeter Armed

Interior Armed

AWAY

Yes Yes Yes Yes

STAY

Yes Yes Yes No

INSTANT

Yes No Yes No

PANIC Keys

There are three PANIC key pairs that can be used to manually initiate alarms and send a

report to the Central Station.

The Panic function is activated when both keys of the appropriate key pair are pressed at the

same time.

The Panic functions are identified by the system as follows:

Keys Keypad Display Function Programmed

1 +

✱

+ #

3 + #

Important: If the Silent Panic function is programmed, it will only be of practical value if

the system is connected to a Central Station.

Relay/Powerline Carrier Device Activation

If relay outputs (via a

4204

4229

) or

Powerline Carrier devices

are used, two keypad

entries available to the user are included. They can manually activate or deactivate the

device(s) for starting or stopping some action, such as turning lights on or off, etc.

These keypad entries are:

[Security Code] + # + 7 + [Device No.]

activates (starts) that device.

[Security Code] + # + 8 + [Device No.]

deactivates (stops) that device.

4285/4286 VIP Module (if used)

Refer to the separate instructions supplied with the Phone Module for information

concerning its operating procedures.

The phone module

cannot

be used to add user codes in this system. User codes must be added

by using a wired keypad.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 143 144

Comentários a estes Manuais

Sem comentários

Security Link SL150 Guia de Resolução de Problemas Página 117

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Security Link SL150