Security Link SL150 Guia de Resolução de Problemas descarregar pdf (Página 88)

SL150 Installation and Setup Guide

16–6

10 XMIT TO CONFIRM

PRESS

✱

TO SKIP

The prompt to confirm appears

This prompt will only appear

if the first prompt on page 16-4 was answered “Yes.” To confirm,

activate the loop input or button that corresponds to this zone.

The system checks for duplicate. If a duplicate exists, a long error

beep will sound.

Press [#] to back up and re-enter the serial and/or loop number.

If Serial or Loop

Numbers do not match

after activating the

transmitter

→

f the serial/loop number combination transmitted does not match

the serial and loop number entered, a display similar to the one

below will appear. If the loop number does not match, it will

also be displayed.

Entd A022-4063

Rcvd

A022-4064

If so, activate the transmitter’s loop input or button one or more

times.

If a match is still not obtained (i.e., summary display does not

appear), press the [#] key twice and enter the correct loop input or,

if correct, press [#] again and then enter the correct serial number.

Zn ZT RC In:

10 03

10 RF:

Note that an “s” indicates that

a transmitter’s serial number

has been enrolled.

•

If the serial number transmitted matches the serial number

entered, the keypad will beep 3 times and a summary display will

appear, showing the programmed information for that zone.

Press [

✱

] go to a blank summary display for entries for the next

zone.

NOTE:

Following the successful enrollment of each wireless device, remove ONE of the

serial number labels from the device and affix it in the appropriate column on the

ENROLLED TRANSMITTERS worksheet of the Programming Form; then enter the other

information (zone number, zone type, loop number, etc.) relevant to that device.

To Remove a Zone

To either temporarily or permanently remove a zone from the system (5800 system):

1. Enter the programming mode:

Key [Installer Code] + 8 + 0 + 0 and press

✱

56.

2. The following display will appear:

SET TO CONFIRM?

0 = NO 1 = YES 0

Press [

✱

] to continue.

3. Enter the zone number and press [

✱

]. A summary display will

appear. As an example, zone 20 is shown.

20 Zone Type

Not Used 00

4. Enter 00. This sets the zone type to Not Used.

Press [

✱

] to continue.

20 Delete Zone?

1 = Yes, 0 = No

5. The next

prompt

will ask whether you want to delete the zone.

1 (Yes) will permanently remove the zone from the system,

while 2 (No) will disable it but retain all data except the

original zone type. You can then go back to this zone later and

put back an active zone type to re-enable it.

A serial number that has been entered for a 5800 system

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 143 144

Comentários a estes Manuais

Sem comentários

Security Link SL150 Guia de Resolução de Problemas Página 88

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Security Link SL150