Security Link SL150 Guia de Resolução de Problemas descarregar pdf (Página 40)

SL150 Installation and Setup Guide

6–4

For button transmitters (RF “keys”), such as the 5801, 5804, and 5804BD, you must assign a

unique zone number to each individual button used on the transmitter. Each button on the

transmitter also has a pre-designated loop or input number, which is automatically displayed

on the keypad.

Programming an RF House ID

Programming an RF House ID (01–31) in field

✱

24 is necessary only if you are using

5827, or 5804BD. An RF House ID is not necessary for other 5800 Series Transmitters, and

the entry should be left at 00 (default) in those cases.

The 5827 reports low-battery status as zone 00.

Transmitter Supervision

Except for some transmitters that may be carried off-premises 5802, 5802CP, 5804, 5804BD,

5827, and 5827BD), each transmitter is supervised by a check-in signal that is sent to the

receiver at 70–90 minute intervals. If at least one check-in is not received from each

supervised transmitter within a 12-hour period, the “missing” transmitter number(s) and the

message CHECK will be displayed.

The supervision for a particular transmitter in the system that may also be carried off the

premises (5801, 5802MN) may be turned off by enrolling it as a “UR” (unsupervised RF) type,

as described later.

5800 Series Transmitters have built-in tamper protection and will annunciate as a “check”

condition if covers are removed.

Transmitter Input Types

All of the transmitters described have one or more unique factory-assigned input (loop) ID

codes. Each of the inputs requires its own programming zone (e.g., a 5804's four inputs

require four programming zones). See Appendix A.

Transmitters can be enrolled as one of the following types:

Type Description

(Supervised RF)

Sends periodic check-in signals, as well as fault, restore, and

low-battery signals. The transmitter must remain within the

receiver's range.

(Unsupervised RF)

Sends all the signals that the “RF” type does, but the control

does not supervise the check-in signals. The transmitter may

therefore be carried off-premises.

(Unsupervised Button RF)

Sends only fault signals. It will not send a low-battery signal

until it is activated. The transmitter may be carried off-

premises.

Transmitter Battery Life

Do not install batteries in wireless transmitters until you are ready to enroll the transmitters during

system programming. After enrolling, batteries need not be removed.

Batteries in the wireless transmitters may last from 4 to 7 years, depending on the

environment, usage, and the specific wireless device being used. Factors such as humidity,

extreme temperatures, as well as large temperature variations may all reduce the actual

battery life in a given installation. The wireless system can identify a true low-battery

situation, thus allowing the dealer or user of the system time to arrange a change of battery

and maintain protection for that given point within the system.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 143 144

Comentários a estes Manuais

Sem comentários

Security Link SL150 Guia de Resolução de Problemas Página 40

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Security Link SL150