Security Link SL150 Guia de Resolução de Problemas descarregar pdf (Página 48)

SL150 Installation and Setup Guide

7–4

Wiring Connections

To wire the Powerline Carrier Device to the control panel, perform the following steps:

1. Splice one end of a 3-conductor cable to the wire ends of the 4142TR Cable supplied with

the 4300 Transformer.

2. Connect the 4142TR Cable Plug to the 9-pin connector on the control (see Figure 24.

Summary of Connections diagram for location of the 9-pin connector).

3. Connect the other end of the 3-conductor cable to the 4300 Transformer, as indicated in

the table below and in the diagram that follows.

4300 TRANSFORMER WIRE CONNECTIONS

4300 Terminal To Terminal on Control

1 (AC) 1 (16.5V AC in)

2 (Ground) 25 Earth Ground terminal

3 (AC) 2 (16.5V AC in)

4300 Terminal 4142TR Cable Wire

4 (Sync) RED (Pin 5 of 9-pin connector)

5 (Data) VIOLET (Pin 1 of 9-pin connector)

6 (Com) WHITE (Pin 4 of 9-pin connector)

123456789

9-PIN CONNECTOR

ON CONTROL BOARD

BLACK

BLUE

BROWN

GREEN

RED

WHITE

YELLOW

GRAY

VIOLET

4142TR CABLE

125 2

Earth

Ground

Sync

Data

Com

4300 TRANSFORMER/INTERFACE

TERMINALS

ON CONTROL

BOARD

THESE WIRES (7, 8, 9) NOT USED

Figure 18. 4300 Transformer Wiring Connections

Programming Relay Outputs

In the SL150, each device must be programmed as to how to act (ACTION), when to activate

(START), and when to deactivate (STOP). Refer to the programming procedures for

✱

80 and

✱

81 interactive modes that are provided in Section 13: Mechanics of Programming,

Section 17: Output Device Programming, and Section 18: Zone Lists for specific

programming details.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 143 144

Comentários a estes Manuais

Sem comentários

Security Link SL150 Guia de Resolução de Problemas Página 48

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Security Link SL150